NX2中的“拉伸至裁剪面”功能，在NX3中如何做？

waq

图示NX2的拉伸至裁剪面，<br>[upload=png]NewUploadFile/2005-12/2005121110331498350.png[/img]<br>[upload=png]NewUploadFile/2005-12/2005121110333087347.png[/img]<br>[upload=png]NewUploadFile/2005-12/2005121110334367489.png[/img]<br>[upload=png]NewUploadFile/2005-12/2005121110335865594.png[/img]<br>NX3中瓷功能在那里？<br>[upload=png]NewUploadFile/2005-12/2005121110371881652.png[/img]<br>[upload=png]NewUploadFile/2005-12/2005121110373447424.png[/img]<br>原来是这样！<br>[upload=png]NewUploadFile/2005-12/2005121111424037524.png[/img]<br>

[此贴子已经被作者于2005-12-11 11:43:17编辑过]

古树临风

<P>起始和结束值下拉菜单里面</P>

waq

谢谢！